Hi,
I’m installing v.2.1.2 on a Vista Business SP2 64bits.
I’ve installed pdfCreator v.0.9.8
I’ve added /ForceInstall to setup.exe
and execute it as administrator.
But setup do not run.
It does’nt give any message.
What must I do?
Thanks you.
Florenci
Hi,
did you try removing the 0.9.8 version manually?
If it can’t be removed, it is recommended to run the installer for 0.9.8 again (should be available on sourceforge) with the /ForceInstall parameter, this will make sure the unins000.dat required for a proper uninstall is there and in the correct version. Afterwards, you should be able to do a regular uninstall of 0.9.8, reboot your computer and install 2.1.2. It is not neccesary do run the entire setup as admin, it will prompt for admin permissions on installing the printer driver.
best regards